Hello, dear forum.
I am looking for help to fix an AMX-4 system. When i try to release a x-ray shot, system shows "X-RAY DISABLE". A blown fuse was found in ROTOR CONTROL board, it was already replace, but again was blown when tried another x-ray release. ROTOR CONTROL was replaced, and filament current was calibrated, but system worked just one day after that. X-RAY DISABLED stays on message display. What could be the cause? Do you have any suggestion?
We supply high-quality refurbished and used imaging equipment and parts to hospitals, imaging centers, and brokers worldwide. We pay top dollar and offer installation, deinstallation, service, and transport. Se habla español info@medilabglobal.com
AnyFE
X-RAY DISABLED
September 13, 2022 09:55
Hello, dear forum.
I am looking for help to fix an AMX-4 system. When i try to release a x-ray shot, system shows "X-RAY DISABLE". A blown fuse was found in ROTOR CONTROL board, it was already replace, but again was blown when tried another x-ray release. ROTOR CONTROL was replaced, and filament current was calibrated, but system worked just one day after that. X-RAY DISABLED stays on message display. What could be the cause? Do you have any suggestion?
to rate and post a comment