We are having problems to go in the menu > Structure Site, when we are in there, the charging bar starts to run but it comes a moment when it stops in (9%) and says that the software was updated in a highest version and it cannot keep running because it has this difference in software.
We need to install this system with two xray tubes. One, is already configured but the other one is not, and there is where we are struggling.
We already check the version of the XCU and it is VF00D, the one we are running. Also checked the ID Host and it is also the same from the Application Key Generation in manuals.
BMI-PMI services nearly every make, model, and modality through our nationwide team of nearly 200 local service engineers. Flexible contracts, 24/7 remote monitoring, and ISO 13485 certification. www.brownsmedicalimaging.com / 800-701-9729
SelmaZamora
STRUCTURE SITE STOPS
May 17, 2018 02:48
Hello Guys,
We are working on a Axiom Iconos R200.
We are having problems to go in the menu > Structure Site, when we are in there, the charging bar starts to run but it comes a moment when it stops in (9%) and says that the software was updated in a highest version and it cannot keep running because it has this difference in software.
We need to install this system with two xray tubes. One, is already configured but the other one is not, and there is where we are struggling.
We already check the version of the XCU and it is VF00D, the one we are running. Also checked the ID Host and it is also the same from the Application Key Generation in manuals.
Please, any recommendation??
to rate and post a comment