I have the problem with one Injector MEDRAD STELLANT D with single head.
First, I had the broken Power Supply 48 V. I replaced it.
One month after that, we get new error.
When I turn on injector on the monitor appears "MEDRAD" (Foto2.jpg) and further not loading.
The board "BASE INTERFACE CARD" in the Base Unit has two keys (transistors) Q2 and Q3 (Foto1.jpg).
On these keys are not comes signal "ON", therefore voltage + 48V and + 15V are not served with a Base Unit to Injector Head.
We replace the cable, which connect Display (DCU) and Base, but the error appear again.
Lightly used system available direct from the end user customer. MONARCH QUEST
Featuring our most advanced, data-driven navigation software with AI-Powered algorithms & advanced imaging integration with the GE HealthCare OEC 3D C-arm.
Alex Trayduk
Problem with MEDRAD Stellant D
June 16, 2015 09:34
Hello everybody.
I have the problem with one Injector MEDRAD STELLANT D with single head.
First, I had the broken Power Supply 48 V. I replaced it.
One month after that, we get new error.
When I turn on injector on the monitor appears "MEDRAD" (Foto2.jpg) and further not loading.
The board "BASE INTERFACE CARD" in the Base Unit has two keys (transistors) Q2 and Q3 (Foto1.jpg).
On these keys are not comes signal "ON", therefore voltage + 48V and + 15V are not served with a Base Unit to Injector Head.
We replace the cable, which connect Display (DCU) and Base, but the error appear again.
Who must send this signal?
Please, help me solve this problem.
to rate and post a comment