Hello: I have a problem with the rotor in a Super 80CP. The x-ray sequence looks ok and the x-rays are release but the rotor doesn´t run and the generator blocks with high kv or mA. I check with the undertable tube and the result is the same. I have made several checks and can´t find the problem. plese let me know if someone has an idea about this problem.
it is really extrange because if you have x ray, then all the secuence must be in order. . . check the rotor ready signal ,. . . this signal apears when rotor is in the righ speed. . do you hear rotor is running ?. . where are you writing from . .?
what error number do you get. ?
regards
We supply high-quality refurbished and used imaging equipment and parts to hospitals, imaging centers, and brokers worldwide. We pay top dollar and offer installation, deinstallation, service, and transport. Se habla español info@medilabglobal.com
EFREN FRANCO
Philips Super 80CP Generator. Rotor problem
October 15, 2013 03:14
Hello: I have a problem with the rotor in a Super 80CP. The x-ray sequence looks ok and the x-rays are release but the rotor doesn´t run and the generator blocks with high kv or mA. I check with the undertable tube and the result is the same. I have made several checks and can´t find the problem. plese let me know if someone has an idea about this problem.
to rate and post a comment
jose antonio sanchez galvan
re: Philips Super 80CP Generator. Rotor problem
October 15, 2013 07:17
it is really extrange because if you have x ray, then all the secuence must be in order. . . check the rotor ready signal ,. . . this signal apears when rotor is in the righ speed. . do you hear rotor is running ?. . where are you writing from . .?
what error number do you get. ?
regards
jose a. sanchez g.
to rate and post a comment
Juan Manuel Esquivel Martinez
re: re: Philips Super 80CP Generator. Rotor problem
October 16, 2013 04:40
HI IM LOOKING PROGRAMMING MASK NUMBER 3.1 -3.2-3.3--3.4 FOR THIS MODEL X RAY SISTEM
COULD YOU HELP ME?
TKS
to rate and post a comment
Juan Manuel Esquivel Martinez
re: re: Philips Super 80CP Generator. Rotor problem
October 16, 2013 04:41
HI I NEED PROGRAMING MASK NUMBER 3.1 UNTIL 3.5
DO YOU HAVE A COPY ABOUT IT
TKS
JUAN MANUEL
to rate and post a comment
Juan Manuel Esquivel Martinez
re: Philips Super 80CP Generator. Rotor problem
October 16, 2013 04:41
YOU MUST CHECK USING THE PROGRAMMING BOOK LOOK ERROR NUMBER AND FIX IT USING PROPER PROGRAMING MASK
to rate and post a comment