I am having trouble with an OEC 9600 C-Arm system.
The system starts to boot up & stops at the end of the "squares". No error is indicated on the "Technique Proccessor Board"
Maybe it is the SRAM card?. I have changed the battery in this card, it did not help. Also I cannot locate another SRAM card or re-format the original.
You certainly have an SRAM problem we have been able to reload this card in windows 95 if you have a lap top with the pcmcia card slots.
jwburnett@radmartxray.com
We are the best choice for all your Endoscopy needs. We have Certified Pre-Owned refurbished and used Endoscopes, and all other related components and
accessories. We are committed to your absolute satisfaction. (513) 469-7267
Rick Smith
OEC 9600 C-ARM Problem
May 16, 2008 12:38
I am having trouble with an OEC 9600 C-Arm system.
The system starts to boot up & stops at the end of the "squares". No error is indicated on the "Technique Proccessor Board"
Maybe it is the SRAM card?. I have changed the battery in this card, it did not help. Also I cannot locate another SRAM card or re-format the original.
Can anybody help.
Regards
RICK
x-ray@neutronx-ray.com.au
to rate and post a comment
john burnett
Re: OEC 9600 C-ARM Problem
September 03, 2009 07:51
You certainly have an SRAM problem we have been able to reload this card in windows 95 if you have a lap top with the pcmcia card slots.
jwburnett@radmartxray.com
to rate and post a comment
naim llapashtica
Re: OEC 9600 C-ARM Problem
September 17, 2011 07:11
mrs
hello
i have problem with sram card in my contry dont have to buy please tell me where to buy this one or 2 sram
to rate and post a comment