Dear friends
Who is expert on CPI Indico 100? When I push the Fluoro foot switch, the rotor will run but there is no fluroscopy and the fluoro timer is still zero. After releasing the foot switch the rotor is still running until I change the post (from fluoro table to bucky stand or Aux)
What is the problem
Best Regards
Kazem
mk.saremi@gmail.com
is it coupled to a digital system or conventional RF system
try to check the II amplifier power supply or a video chain
also , may be you lost the fluoro configuration in gen.
Dear Tahar
This generator is coupled to a conventional RF table (made by GMM for BMI - BRT 20). I found the fault in video chain and removed it. Now I have fluoroscopy . But after releasing the foot switch, there is no X-ray but the rotor is still running. In order to stop the rotor running,I change the workstation (from fluoro to Rad).Let me know what is the problem.
Kazem Saremi
Indico 100 generator
December 07, 2012 10:08
Dear friends
Who is expert on CPI Indico 100? When I push the Fluoro foot switch, the rotor will run but there is no fluroscopy and the fluoro timer is still zero. After releasing the foot switch the rotor is still running until I change the post (from fluoro table to bucky stand or Aux)
What is the problem
Best Regards
Kazem
mk.saremi@gmail.com
to rate and post a comment
tahar nouri
re: Indico 100 generator
December 07, 2012 11:30
is it coupled to a digital system or conventional RF system
try to check the II amplifier power supply or a video chain
also , may be you lost the fluoro configuration in gen.
to rate and post a comment
Kazem Saremi
re: re: Indico 100 generator
December 08, 2012 11:18
Dear Tahar
This generator is coupled to a conventional RF table (made by GMM for BMI - BRT 20). I found the fault in video chain and removed it. Now I have fluoroscopy . But after releasing the foot switch, there is no X-ray but the rotor is still running. In order to stop the rotor running,I change the workstation (from fluoro to Rad).Let me know what is the problem.
to rate and post a comment
KONSTANTINOS PATTICHIS
re: re: re: Indico 100 generator
December 08, 2012 07:43
You have configuration problem on the generator, follow the service manual.
to rate and post a comment
Fysares Delali
re: Indico 100 generator
December 09, 2012 01:55
Dear Kazem, please send me e-mail. I have configration menu settings...fysares@hotmail.com
to rate and post a comment
rsimaging
re: Indico 100 generator
December 09, 2012 05:00
Please check your configuration...I would look at your fluro hang time in setup..
to rate and post a comment