I have a DAS problem with a TCT-600. When I do a profile of the data from a scan on air the bell curve has a sawtooth waveform. The axial sacns have hard rings.
dear johnnie,
Did you check the Sinogram of the image?If you see some vertical lines ,we can consider that problem would be from integrator or Adc.You should try also offset check with air than check the data of channels.
You can send me some picture data and we can try to help you.We have all boards for spare if you want.
blent temiz.
bbtek@ada.net.tr
HIGH QUALITY fully tested & refurbished systems to manufacturer specifications like new. Installation & service support worldwide. Parts & tubes in stock with warranty. Sales@Elsmed.com
Johnnie Owen
DAS Control problem
December 15, 2004 01:58
I have a DAS problem with a TCT-600. When I do a profile of the data from a scan on air the bell curve has a sawtooth waveform. The axial sacns have hard rings.
916 776 1836
jowen@teal.net
to rate and post a comment
Barbaros Bulent Temiz
Re: DAS Control problem
December 25, 2004 05:50
dear johnnie,
Did you check the Sinogram of the image?If you see some vertical lines ,we can consider that problem would be from integrator or Adc.You should try also offset check with air than check the data of channels.
You can send me some picture data and we can try to help you.We have all boards for spare if you want.
blent temiz.
bbtek@ada.net.tr
to rate and post a comment