Ge Ct Lightspeed Ls3X Errors 183182 And 214080 - Técnicos de mantenimiento Foro
Ubicación actual:
> GE CT Lightspeed LS3.X errors 183182 and 214080

GE CT Lightspeed LS3.X errors 183182 and 214080

Tags: CT, GE


Ali AlZein

GE CT Lightspeed LS3.X errors 183182 and 214080

August 13, 2019 10:42

I am dealing with GE CT Lightspeed LS3.x

I am getting an error 183182 on Tube Warm up

host:obc error:183182
i/o board pilot relay are closed. PDU pilot relay not energized. BCSTAT=0; HVDC rail voltage=215v.

and getting an error 214080 upon KV & mA test

host:obc error:214080
HVDC BUS Voltage is present while backup contactor pilot relay indicates a de-energized state, gentry i/o relay k251 and k245 are energized
hvdc bus voltage:210 V
gentry i/o address:FFAFBFH, bit:D4 expected 1 actual :0

Please guide me through the right Troubleshooting Flowchart to figure out the root cause of these errors.

Upon turning off the power at the PDU, I tested the resistance across A2TS1 cables at the PDU and these were the readings:
Red to Ground 53 K ohm
Black to Ground 50 K ohm
Black to Red 451 Ohms
I tested the phase to phase voltage at the input to the PDU and all read around 380VAC, and phase to ground around 215VAC.

Your help is much appreciated.

Log inor Register

to rate and post a comment

PHILIPS MX8000 & Brilliance Systems & Spare Parts In Stock Now!

HIGH QUALITY fully tested & refurbished systems to manufacturer specifications like new. Installation & service support worldwide. Parts & tubes in stock with warranty. Call 813-925-1314 DOTmed Certified DOTmed 100