hi i need help with this ge brightspeed 8slice if anyone can give me service manual.
error
when starting up laser indicator blink and cannot initialize.
DCB: down, CCB:down, TCB:down, JIDI:down, TGP/ORP:down
Check your gantry to console Ethernet connection...then the Ethernet connection between gantry base and TGP
Check DARC to host connection
What's LED status on TGP?
lead status from gantry base to eth port D is green only no other light. i also replace tgp board, icom assembly with swich hub, motherboard also but still desame error. do i have to replace orp coz last time i check orp light also blinking.
Our engineers are trained strictly on Siemens & GE PET to Guarantee an expert on all service calls. Our large inventory of PET & PET/CT systems & parts
allows us to provide a TRUE Turn-key solution. Ph:866-645-7457
Nicholas Lirazan
Ge 8slice service manual needed
January 16, 2020 10:28
hi i need help with this ge brightspeed 8slice if anyone can give me service manual.
error
when starting up laser indicator blink and cannot initialize.
DCB: down, CCB:down, TCB:down, JIDI:down, TGP/ORP:down
to rate and post a comment
(47)
CRAIG WAMBURA
re: Ge 8slice service manual needed
January 17, 2020 09:29
Check your gantry to console Ethernet connection...then the Ethernet connection between gantry base and TGP
Check DARC to host connection
What's LED status on TGP?
Let's resolve your issue.
to rate and post a comment
Nicholas Lirazan
re: re: Ge 8slice service manual needed
January 24, 2020 09:58
lead status from gantry base to eth port D is green only no other light. i also replace tgp board, icom assembly with swich hub, motherboard also but still desame error. do i have to replace orp coz last time i check orp light also blinking.
to rate and post a comment