re: Clearview Mammo CR error when sending to GE RWS
February 18, 2014 09:03
Hey Barry I am interested to know if you just set up this node, or if it just started giving this error. I just recently ran across this problem, it was a configuration problem on the Fuji side when the node was set up, Regards
(8)
Barry Walgamotte
Clearview Mammo CR error when sending to GE RWS
February 17, 2014 07:57
I'm getting an error when sending to GE RWS from Fuji Mammo clear view 1.
The error says
" [51012] failed in reading of the gray level correction file"
* " there is no gray level correction file (AEName.lut) corresponding to the output device, or the file format is invalid"
>Confirm the gray level correction file
Can anyone help with this error is this something on GE side or Fuji Cr I have to look at
Barry W.
Barryies@bellsouth.net
to rate and post a comment
Shawn Broussard
re: Clearview Mammo CR error when sending to GE RWS
February 18, 2014 09:03
Hey Barry I am interested to know if you just set up this node, or if it just started giving this error. I just recently ran across this problem, it was a configuration problem on the Fuji side when the node was set up, Regards
to rate and post a comment
(8)
Barry Walgamotte
re: re: Clearview Mammo CR error when sending to GE RWS
February 18, 2014 09:17
It was a node that I just setup .....what configuration do I need to change ...I never had this problem before setting a node up
Thanks
to rate and post a comment
Raj Vadgama
re: re: re: Clearview Mammo CR error when sending to GE RWS
February 26, 2014 08:23
Hi Barry,
I was wondering if you had any luck with this as I am experiencing the same issue?
Any help would be much appreciated.
Thanks
to rate and post a comment
(8)
Barry Walgamotte
re: re: re: re: Clearview Mammo CR error when sending to GE RWS
February 26, 2014 10:15
Yes Shawn that replied to this thread helped what is your email I can copy it to you
to rate and post a comment
Raj Vadgama
re: re: re: re: re: Clearview Mammo CR error when sending to GE RWS
February 26, 2014 12:04
My email is raj@veterinaryxrays.co.uk.
Thanks Barry
to rate and post a comment
Alessio Ferraro
re: re: re: re: re: Clearview Mammo CR error when sending to GE RWS
July 02, 2015 05:24
I have a similar problem, if possible i would like to know how to configure the node properly.
My email is a.ferraro@ib-santalucia.it
to rate and post a comment