YOM: 2011 MAR
Modes:
NCPAP
NCPAP with breath rate monitoring and low rate alarm
BiPhasic (time triggered)
BiPhasic (time triggered) with breath rate monitoring and low rate alarm
BiPhasic tr (patient triggered) with breath rate monitoring, low breath rate alarm and apnea back up (Comprehensive models only)
Controls:
Time High (T-High) – 0.1 – 3.0 seconds
Rate (R) 1-120 (Non-U.S. Configuration Parameters) 1-54 (U.S. Configuration Parameters)
Apnea Interval
(Tapnea) – 10-30 seconds, 5 second intervals (Non-U.S. Configuration Parameters)
(TLBR) – 10-30 seconds; 5 second intervals (U.S. Configuration Parameters)
NCPAP / Pres Low flow meter – 0-15 L/min, accuracy ± 15% of selected output
Pres High flow meter – 0-5 L/min, accuracy ± 15% of selected output
Manual Breath – X 1•%O2 – 21 -100%
Monitors:
CPAP
PEEP
MAP
PIP
%O2
I:E ratio
Spontaneous rate (Rsp)
Battery charge level
Alarms
High airway pressure – 3 cmH2O above measured airway pressure
Airway over-pressure limit alarm
maximum 11 cmH2O in NCPAP and time triggered BiPhasic mode
maximum 15 cmH2O in patient triggered BiPhasic tr mode
Low airway pressure – 2 cmH2O below measured airway pressure or 1.5 cmH2O if otherwise would be zero
High and Low delivered Oxygen concentration ±5% of setting. Minimum and maximum delivered FiO2 is 18 and 104% respectively
.Low breath rate alarm
Low battery charge level
Flat battery
Input gases failure
Alarm volume (electronic alarms) 70 dBa at 1 meter
Pneumatic Supply
Patient Gas Outlet: 15 mm standard taper fitting
Patient Pressure Input: 4.5 mm Luer taper fitting
Gas Supply: Nominal 4 bar or 60 psi, clean, dry medical air and oxygen
Range: 40.61 to 87 PSI; Maximum differential pressure 29 PSI
Manometer: Range 0 to + 20 cmH2O, accuracy, ± 2% of span
Gas Connections: Standard DISS, NIST or Air Liquide connectors
Physical
•Dimensions(Driver only)-
•(W x H x D) 26 x38 x 23.5 cm
•Weight (Driver only)-•8.8 kg
Return Policy
Items are sold as-is with no returns or refunds available unless explicitly stated.
